DIY RFID Environment Monitoring Access Display Electronic Starter Kit For Arduino

Note: Package with plastic box No instruction supply Package includes:   1 x Project Box (22.5*15.5*6cm) 1 x UNO R3 Compatible Board 1 x USB Cable 1 x 1 digit 7-segment Display 1 x 4 digit 7-segment Display 1 x Dot Matrix Display 8x8 1 x Shift Resister 74HC595N 1 x Foam Pad 1 x Stepper Motor 1 x DC Motor 1 x Servo Motor (SG90) 1 x Remote 1 x LCD1602 Character Display 1 x Stepper Motor Driver Board 1 x Arduino Extended Board              1 x 830 Holes Breadboard                          10 x Resistor (220Ω)                        10 x Resistor (330Ω)                       10 x Resistor (1k)                        10 x Resistor (4.7k)                       10 x Resistor (10k)                      1 x 9V Battery Connection for Ardunio    1 x Ultrasonic Sensor                    1 x Active buzzer                        1 x Passive buzzer                       1 x Potentiometer                       2 x Infrared emitter                                      1 x Infrared receiver                   2 x Photosensitive resistor              1 x Arduino IR receiver                  1 x Temperature sensor LM35              2 x Vibration switch SW-520D             1 x Electronic component box             4 x NPN Transistor (S8050)  4 x PNP Transistor (S8550)  4 x Big Key                              4 x Key Cap                              1 x 40Pin Header                         10 x Red   LED                          10 x Green LED                           10 x Blue  LED                          49 x 12cm Jumper Wire (Male to Male)     20 x Dupont wire (Female to Male)        1 x Breadboard Power Supply 1 x Fan 1 x RC522 RFID 1 x Color Ring Card 1 x Joystick  1 x Time Module DS3231 1 x Keyboard 1 x DHT11 Temperature and humidity module 1 x Water-level Sensor 1 x Rain Sensor 1 x Siol Humidity 1 x Battery Pack 1 x RGB LED Module 8 x 4148 Diodes